It’s no secret I have this new hobby revolving around stenciling and through a lot of practice I’ve figured out what works and what doesn’t to achieve a good stencil transfer. I’m sharing those tips here and will use this post as a reference for future projects.
Are you ready? First tip is this, relax and enjoy the process because this is a fun activity that really isn’t that difficult.
Where to purchase Stencils?
My favorite stencil source is Old Sign Stencils, I also like to purchase single letters found at craft stores like Hobby Lobby.
Since stenciling has become popular finding neat designs isn’t that difficult because they’re everywhere. But I’ve listed my favorites to help you find what you’re looking for.
Believe it or not scrap wood has been a huge bonus for improving the transfer process.
For that reason I keep a bucket of wood pieces in the workshop for easy access; this wood is just leftovers from previous projects.
Necessary Supplies for Success
- Wood or some type of surface to stencil transfer
- A good quality stencil
- Scrap wood
- Chalk or Mineral Paint, any brand will work and they’re easy to use.
- Stencil Brushes – I prefer the short ones with a nice brush where pieces don’t fall out, spend a little more for good brushes and wash them after each use and they’ll last a long time.
- Painters Tape
Little Tip, I use Martha Stewart’s stencil brushes, I’ve tried others and they’re not as good. You can purchase at Michael’s or Amazon, they’re Awesome and perfect for wood and fabric transfers.
NOTE: Later on I discovered Cutting Edge Stencil brushes and they’re amazing. Learn more here.
Beginning a Stencil Project
- Practice your technique first prior to using the following tips to your finished project.
- Once you have a ready to go transfer surface make sure it’s clean from debris.
- Take Painters tape and attach the stencil to the surface and cover open areas you don’t want transferred.
Loading the Brush
Loading the brush is so important and where things fall apart if not done correctly. Here’s my biggest tip, less is BEST! This is no joke because every time I make a mistake it’s paint related or because I didn’t tape down the stencil. I’ll show you what I’m referring to in a minute, keep reading!
- Dab the board with paint
- Add paint to your brush
- Then brush the excess paint off onto the open space of the scrap wood
- Repeat this process every time you load the brush before you stencil
With this stencil some of my letters lifted because it’s been used many times and no longer lays flat. For that reason I didn’t tape the stencil in place because I knew I would have to hold it down anyways. Note – regardless I should have taped it. Keep Reading to find out why…
The transfer is a slow dot process over the open areas, sometimes with detailed stencils such as this it’s a good idea to hold things down in addition to the painters tape.
Another tip is to spray the back side of the stencil with craft adhesive; I don’t recommend this because that stuff doesn’t peel off. Learning to stencil without adhesive takes practice and remembering to always load your brush correctly. You don’t need the adhesive, you can do this!
The Big Reveal
Once the stencil is transferred, lift and see how you did. Notice on the letter “e” I had a slight move outside the line. This was because my stencil jerked because I failed to tape the stencil. This was intentional so you could see what happens when you don’t follow the steps correctly.
An error isn’t the end of the world; you can actually remove them by using sand paper. Allow the transfer to dry 100%, this may take 30 minutes or so. If you fail to let it dry this increases additional smudging.
Here’s what you do, sand over the goof and remove it. Wasn’t that simple? This little tip can save a project and remind you to slow down and not skip any steps. Hope you enjoyed and happy stenciling I think it could be a big thing for the next couple of years.